1. The area for installation should be clean, dry and free from any loose
dirt or gravel. Try to avoid placing the loop in areas on the pavement that are
broken or cracked. This condition may shorten the life of the loop
significantly.
2. Unfold the loop, positioning it top side down. Remove the release sheet
form the loop only leaving the film on the protected portion of the lead.
3. Turn the loop over and place in position. Tread on the entire upper
surface of the loop to ensure a complete bond.
4. Next, remove the release sheet from the protected lead and place in
position and secure as before. If the lead is extremely long, this process may be
done in sections, starting at the loop and working to the side of the road.
|
Special Note: When temperatures are 40° F and below, the surface should be heated to dissipate any moisture that may be present and bring the surface to the required bonding temperature of 40°F & above. |
.
| Tape Style Temporary |
| Inductive Loop |
| Examples of Part #'s, Model #'s & Sizes | ||
| PART # | MODEL | SIZE |
| T-LS8-6/2018 | LS8 | 2.0' X 6.0' |
| T-LS8.5-6/2018 | LS8.5 | 2.5' X 6.0' |
| T-LS9-6/2018 | LS9 | 3.0' X 6.0' |
| T-LS9.5-6/2018 | LS9.5 | 3.5' X 6.0' |
| T-LS10-6/2018 | LS10 | 4.0' X 6.0' |
| T-LS12-6/2018 | LS12 | 6.0' X 6.0' |
|
Additional Information |
|
Sizes, Lead Lengths and Configurations other than listed in the matrix are available upon request. Please call for quote. |
|
Other wire insulation grades, gauges and lamination schedules are available. Please call for information. |
|
All temporary tape style loops are constructed with six feet of protected lead and 20' of unpro-tected non-spliced twisted pair unless otherwise specified. |
•